Note:
If the sunroof motor is new, cycle the sunroof seven?€‰(7) times to teach the motor/actuator initialization process.
Perform the initialization/teach procedure on a reinstall motor or a new motor. Ensure the electrical harness on the headliner is connected to the sunroof motor, battery power is applied, and the ignition switch is ON.
Note:
If the sunroof window doesn't go to the vent open position first time, release the switch and press the switch again.
If the initialization/teach procedure is not carried out completely, it has to be started again.
Sunroof Switch Replacement
Roof DrainageAirbag System
The vehicle has the following airbags except where noted below:
A frontal airbag for the driver.
A frontal airbag for the front outboard passenger.
A knee airbag for the driver.
A knee airbag for the front outboard passenger.
A seat-mounted side impact airbag for the driver.
A seat-mou ...
Body Rear Seat Back Trim Panel Replacement (with AMA/AM7)
Body Rear Seat Back Trim Panel Replacement
Callout
Component Name
Preliminary Procedure
Remove the body side trim panel. Refer to Body Side Trim Panel Replacement.
1
Body Rear Seat Back Trim Pane ...
Roof Outer Panel Replacement (4NB)
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Disable the SIR system. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove all ...