Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Sunroof Window Seal Replacement

Chevrolet Sonic Repair Manual / Body / Glass & Windows / General / Sunroof Window Seal Replacement

Removal Procedure
  1. Remove the sunroof window panel. Refer to Sunroof Window Replacement.


  2. Remove the seal from the window panel frame by pulling the seal away at one point and continuing around the perimeter of the frame.
  3. Clean around the edge of the inside surface of the window with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened lint free cloth, allow to air dry.
Installation Procedure
  1. Using a clean dampened cloth wipe the seal with a small amount of the same window cleaner in order to ease installation.
  2. \\\
  3. Position the sunroof window panel seal onto the window frame, locating the starting end of the seal at the relief notch in the center of the passenger side of the frame.
  4. Note:

    Ensure that the seal is properly seated around the entire perimeter of the window frame.

  5. Firmly press the window seal into the retainer edge of the sunroof window, a 50/50 mixture of soap and water by volume will help in the installation.
  6. Install the sunroof window panel. Refer to Sunroof Window Replacement.
  7. Adjust the window panel height. Refer to Sunroof Window Height and Opening Fit Adjustment.
  8. Inspect sunroof for proper operation.
Sunroof Window Replacement
Sunroof Window Replacement Callout Component Name 1 Sunroof Window Bolt?€‰(Qty:?€‰4) Caution: Refer to F ...

Urethane Adhesive Description
For replacement of any adhesive-installed window, use the full cut method only. Use an adhesive that is approved by GM, Specification GMW-15672. Use these materials based on specific manufacturer. D ...

Other materials:

Air Inlet Grille Panel Replacement
Air Inlet Grille Panel Replacement Callout Component Name Preliminary Procedure Remove both wiper arm assemblies. Refer to Windshield Wiper Arm Replacement. Remove both outer hood rear seals. Refer to Hood Rear Seal Repla ...

Master Cylinder Replacement
Removal Procedure Warning: Refer to Brake Fluid Irritant Warning. Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution. Place the ignition switch in the OFF position. Remove the battery. Refer to Battery Replacement. Disconnect ...

Evaporative Emission Control System Description
Typical Evaporative Emission (EVAP) System Hose Routing Diagram (1) Evaporative Emissions (EVAP) Purge Solenoid Valve (2) EVAP Canister (3) EVAP Vapor Tube (4) Vapor Recirculation Tube (5) ...

© 2014-2022 Copyright www.csmans.com
 
0.0066