Chevrolet Sonic Repair Manual: Suspension
- Drivetrain and Front Suspension Frame Replacement
- Drivetrain and Front Suspension Frame Skid Plate Replacement
- Front Suspension Description and Operation
- Front and Rear Suspension Modification Kit Installation
- Rear Axle Replacement
- Rear Suspension Description and Operation
- Special Tools
- Trim Height Inspection
- Ball Joint Inspection
- Rear Spring, Insulator, and Jounce Bumper Replacement
- Rear Compartment Lid Hinge Torque Rod Replacement
- Lower Control Arm Replacement
- Front Wheel Bearing and Hub Replacement
- Rear Wheel Bearing and Hub Replacement (Disc Brake)
- Rear Wheel Bearing and Hub Replacement (Drum Brake)
- Front Wheel Bearing and Hub Replacement
- Hub/Axle Flange and Wheel Stud Runout Inspection
- Rear Wheel Bearing and Hub Replacement (Disc Brake)
- Rear Wheel Bearing and Hub Replacement (Drum Brake)
- Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
- Steering Knuckle Replacement
- Liftgate Strut Replacement
- Strut Assembly Removal and Installation
- Strut, Strut Component, or Spring Replacement
- Shock Absorber Disposal
- Shock Absorber Replacement
- Strut and Shock Absorber Inspection
- Strut and Shock Absorber Inspection (Shock Absorber)
- Rear Spring, Insulator, and Jounce Bumper Replacement
- Stabilizer Shaft Link Replacement
- Stabilizer Shaft Replacement
Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
Ensure that the steering wheel is set in a straight ahead position.
Loosen the tie rod jam nut (1).
Adjust the toe to specification by turning the inner tie rod (2). Refer
...
Drivetrain and Front Suspension Frame Replacement
Special Tools
EN-45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Support the radiator and condenser from above using the upper brackets
...
Other materials:
Rear Side Door Outer Panel Replacement
Removal Procedure
Warning: Refer to Glass and Sheet Metal Handling Warning.
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed.
Disable the SIR System. Refer to SIR Disabling and Enabling.
Dis ...
Hood Rear Weatherstrip Replacement
in
Hood Rear Weatherstrip Replacement
Callout
Component Name
1
Hood Rear Weatherstrip
Procedure
The hood rear weatherstrip is held in place with 10?€‰plastic retainers
that are part of the air inlet grille. ...
Air Intake System Description
Circuit/System Description
The primary function of the air intake system is to provide filtered air
to the engine. The system uses a filter element mounted in a housing. The filter
housing is remotely mounted and uses intake ducts to route the incoming air
into the throttle body. T ...
0.0055