Chevrolet Sonic Repair Manual: Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
Sedan Taillamp Shown, Hatchback Taillamp Similar
- Back-up Lamp
- Turn Signal Lamp
- Stop Lamp/Taillamp
- Sidemarker Lamp
To replace one of these bulbs:
- Open the trunk.
- Remove the two screws, which secure the taillamp assembly.
- Remove the taillamp assembly by pulling it straight back until the two posts disengage from the grommets.
- Remove the bulb socket from the taillamp assembly by turning it counterclockwise.
- Remove the bulb by pulling it straight out.
- Install a new bulb into the bulb socket.
- Install the bulb socket into the taillamp assembly by turning it clockwise.
- Install the taillamp assembly and tighten the two screws.
Stop and Turn Signal Lamp Bulb Replacement (Sedan)
Stop and Turn Signal Lamp Bulb Replacement
Callout
Component Name
Preliminary Procedure
Remove the tail lamp assembly. Refer to ...
Other materials:
Rear Bumper Fascia Replacement (Hatchback)
Rear Bumper Fascia Replacement
Callout
Component Name
Preliminary Procedures
Remove the screws from the rear wheelhouse liners to the rear fascia.
Refer to Rear Wheelhouse Liner Replacement.
Disconnect the rear electrical ...
Center Pillar Reinforcement Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Warning: Refer to Glass and Sheet Metal Handling Warning.
Note: The center pillar upper stiffener is made of Dual Phase
Steel and should be replaced only at ...
Camshaft Position Actuator Adjuster Removal
Special Tools
EN-6340 Camshaft Adjuster Locking Tool
EN-6628-A Camshaft Locking Tool
For equivalent regional tools, refer to Special Tools.
Note: The right half of the EN-6340 locking tool can be
recognized by the lettering "right", arrow, on the tool.
Pre ...
0.0068