Chevrolet Sonic Repair Manual: Throttle Body Assembly Removal

Throttle Body Assembly Installation

Install a NEW throttle body seal. Install the throttle body (1). Caution: Refer to Fastener Caution. Install the 4 throttle body bolts (2) and tighten to ...

Throttle Body Assembly Replacement

Removal Procedure Disconnect the throttle body wiring harness connector. Remove the charge air cooler outlet air hose from the throttle body. Refer to Charge Air Cooler Outlet ...

Other materials:

Multi-Axis Acceleration Sensor Module Programming and Setup
Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the Multi-axis Acceleration Sensor or Inertia Sensor Module (IMU) is not properly configured with the correct calibration software, the Electronic Brake Control Module will ...

Roof Outer Panel Replacement (4NB)
Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning. Disable the SIR system. Refer to SIR Disabling and Enabling. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove all ...

Evaporative Emission Canister Replacement
Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the EVAP canister cover fasteners (1) and cover (2). Warning: Do not breathe the air through the EVAP component tubes or hoses. The fuel vapors inside t ...