|
Callout |
Component Name |
|---|---|
Preliminary Procedure
|
|
|
1 |
Throttle Body Heater Inlet Hose Clamps |
|
2 |
Throttle Body Heater Inlet Hose Procedure
Disconnect the throttle body heater inlet hose clamps from the throttle body. |
Heater Inlet Hose Replacement (LUV)Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
Sedan Taillamp Shown, Hatchback Taillamp Similar
1. Back-up Lamp
2. Turn Signal Lamp
3. Stop Lamp/Taillamp
4. Sidemarker Lamp
To replace one of these bulbs:
1. Open the trunk.
2. Remove the two screws, which secure the taillamp assembly.
3. Remove the taillamp assembly by pulling it stra ...
Sun Load Temperature Sensor Replacement
Sun Load Temperature Sensor Replacement
Callout
Component Name
1
Sun Load Temperature Sensor Bezel
2
Sun Load Temperature Sensor
Procedure
Disconnect the electrical connector.
Twist ...
3-5-Reverse and 4-5-6 Clutch Housing Disassemble (6T30/40/45/50 - Gen 2)
Table 1:
Turbine Shaft, Reluctor Wheel and Piston Removal
Table 2:
4?? Clutch Plate Removal
Table 3:
4?? Clutch Piston Removal
Table 4:
Reluctor Wheel and Piston Removal
Table 5:
3? Reverse Clutch Plate Removal
Turbine Shaft, Re ...