|
Callout |
Component Name |
|---|---|
Preliminary Procedure
|
|
|
1 |
Throttle Body Heater Inlet Hose Clamps |
|
2 |
Throttle Body Heater Inlet Hose Procedure
Disconnect the throttle body heater inlet hose clamps from the throttle body. |
Special Tools
Throttle Body Heater Inlet Pipe Replacement (LUW)Instrument Panel Knee Bolster Replacement
Instrument Panel Knee Bolster Replacement
Callout
Component Name
Preliminary Procedures
Disable the SIR system. Refer to SIR Disabling and Enabling.
Remove the driver inflatable restraint instrument panel lower module.
...
Throttle Body Assembly Replacement
Removal Procedure
Disconnect the throttle body wiring harness connector.
Remove the charge air cooler outlet air hose from
the throttle body. Refer to Charge Air Cooler Outlet
Air Hose Replacement.
Remove the 4 throttle body fasteners (3).
Remo ...
Drive Range, First Gear Engine Braking (Gen 1)
When the gear selector lever is moved to the Drive (D) range from the Neutral
(N) position, the transmission will provide engine braking. In this operating range,
the normally-low 1234 pressure control solenoid 5 is commanded ON and, in the engine
braking mode, the following changes occur with ...