Chevrolet Sonic Repair Manual: Throttle Body Inspection and Cleaning
Note:
Over extended time and mileage, deposits may accumulate on the back of the throttle valve plate. The source of the deposit is exhaust gas. Typically these deposits pose no problem. Occasionally the deposit may accumulate to a point where perceived pedal effort or throttle valve movement is effected.
- Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.
- Inspect the throttle body bore and the throttle valve plate for deposits. You will need to open the throttle valve in order to inspect all surfaces.
- Clean the throttle body bore and the throttle valve plate using a clean shop towel with an appropriate cleaner.
- Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.
Throttle Body Heater Outlet Pipe Replacement (LUW)
Throttle Body Heater Outlet Pipe Replacement
Callout
Component Name
Preliminary Procedure
Drain the cooling system. Refer to Co ...
Throttle Body Installation
Install the throttle body (2) and a NEW throttle body
seal ring (1).
Caution: Refer to Fastener Caution.
Install the 4 throttle body bolts (3) an ...
Other materials:
Interior Lighting
Dome Lamps
The dome lamp controls are in the headliner above the rear seats.
: Press to turn the lamps off, even
when a door is open.
: When the button is returned to
the middle position, the lamps turn on automatically when a door is opened.
: Press to turn on the dome lamps.
Reading ...
Brake Fluid Effects on Paint and Electrical Components Caution
Caution: Avoid spilling brake fluid onto painted surfaces, electrical
connections, wiring, or cables. Brake fluid will damage painted surfaces and
cause corrosion to electrical components. If any brake fluid comes in contact
with painted surfaces, immediately flush the area with water. I ...
Air Conditioning O-Ring Seal Replacement
Removal Procedure
Disassemble the A/C refrigerant components. Refer to the appropriate
repair procedure
Note: Cap or tape the open A/C refrigerant components immediately
to prevent system contamination.
Cap or tape the A/C refrigerant components.
...
0.006