Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the timing belt. Refer to Timing Belt Replacement. |
|
1 |
Timing Belt Idler Pulley Bolt Caution: Refer to Fastener Caution.
Special Tools
EN-45059 Torque Angle Sensor Kit For equivalent regional tools, refer to Special Tools. |
2 |
Timing Belt Idler Pulley Procedure
Ensure to use a NEW BOLT whenever the timing belt idler pulley is removed. |
Rear Wheel Bearing and Hub Replacement (Disc Brake)
Special Tools
EN–45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and suitably support the vehicle. Refer to Lifting and Jacking
the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and Insta ...
Crankshaft Position System Variation Learn
Note: The crankshaft position sensor system variation learn procedure
is required when the following service procedures have been performed, regardless
of whether DTC P0315 is set:
Engine replacement
Engine control module (ECM) replacement
Crankshaft damper replacement
...
Shift Control Housing Replacement
Removal Procedure
Set the parking brake.
Shift the transmission to the Neutral position.
Remove the battery tray. Refer to
Battery Tray Replacement.
Remove the brake master cylinder assembly from the
power brake booster. Refer to Master Cylinder Replacement.
...