Chevrolet Sonic Repair Manual: Tire and Wheel Balancing (Wheel Pilot Bore Greasing)
- Beginning with MY 2011 vehicle, pilot bore grease should be applied.
- To enable this, grease must be applied to the pilot bore to prevent the wheel from seizing onto the hub.
- Refer to Adhesives, Fluids, Lubricants, and Sealers for pilot bore lubricant part number.
- Do not use any penetrating oils, grease or other lubricants on the wheel studs to aid in removal or installation. Always install wheels to clean, dry wheel studs only.
- The dimension between the wheel and hub has been tightened in order to reduce mounting variation that results in 1st order tire variation. Only a very small amount of grease should be applied to the inner diameter of the wheel hub pilot hole of the wheel. Do not apply it to the entire pilot hole of the wheel or to the wheel bearing flange.
Tire and Wheel Balancing (Road Force Variation (RFV))
ALL wheel/tire assemblies must have a RFV within spec before being mounted
on vehicle.
Important: If a wheel/tire assembly is not within the RFV specification
after match mounting, th ...
Tire and Wheel Install Instruction
Installation Instructions Part Number
19156306
Note: Please read the following instructions carefully before mounting
the wheels on the vehicle.
Labels
Your application may require a ne ...
Other materials:
Front Wheelhouse Liner Replacement (Rear)
!l
Front Wheelhouse Liner Replacement
Callout
Component Name
Preliminary Procedure
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and
Installation.
1
Front Wheelhouse Rear Li ...
Starting System Description and Operation
The starter motors are non-repairable starter motors. They have pole pieces that
are arranged around the armature. Both solenoid windings are energized. The pull-in
winding circuit is completed to the ground through the starter motor. The windings
work together magnetically to pull and hold in ...
Charge Air Cooler Inlet Air Hose Replacement
Removal Procedure
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
Loosen the charge air cooler inlet air pipe clamp (1) at the ...
0.0061