Chevrolet Sonic Repair Manual: Tire Dismounting and Mounting (Lubricant)
- Lubricant should be applied to form a thin, just visible layer, on the bead foot and bead outer areas. There should not be any visible clumps of lubricant.
- Never use soap or any lubricant net specifically designed for tire assembly.
- Lubricant is used to achieve accurate seating between the tire bead and the seat on the rim.
- Apply tire lubricant, refer to Adhesives, Fluids, Lubricants, and Sealers to both tire and wheel beads for full circumference.
- Immediately assemble tire to wheel and inflate.
- If assembly is not completed within five (5) minutes of being lubricated, both the tire and wheel must be re - lubricated for proper assembly and inflation.
Important:
Tire Dismounting and Mounting (Bead Exercising)
Most effective if done within 5 minutes of lube application.
Tire exercising is required for all tires and should be done prior to balancing
and checking for RFV.
Lack of bead exercising w ...
Tire Dismounting and Mounting (Match Mounting)
Match mounting is required on any wheel/tire assembly not within RFV specification.
Important: If a wheel/tire assembly is not within the RFV specification
after match mounting, the ti ...
Other materials:
Hood Rear Seal Replacement
Hood Rear Seal Replacement
Callout
Component Name
1
Hood Rear Seal
Procedure
Clean the area where the seal will be mounted. Use a suitable solvent
with a mixture of 50?€‰percent isopropyl alcohol and 50?â ...
Catalytic Converter Heat Shield Replacement (LUV)
Catalytic Converter Heat Shield Replacement
Callout
Component Name
Warning: Refer to Exhaust Service Warning.
1
Catalytic Converter Heat Shield Fasteners (Qty: 4)
Caution: Refer ...
Drive Range, Sixth Gear (Gen 2)
As vehicle speed increases, the transmission control module (TCM) processes input
signals from the automatic transmission input and output speed sensors, the throttle
position sensor and other vehicle sensors to determine the precise moment to command
ON the normally-low 26 pressure control so ...
0.0059