Chevrolet Sonic Repair Manual: Tire Dismounting and Mounting (Match Mounting)
- Match mounting is required on any wheel/tire assembly not within RFV specification.
- All wheel weights should be removed prior to match mounting.
- Match mounting is required on any assembly where the RFV readings are out of spec.
- Match mounting identified in the high spot of the tire and matches it with the low spot on the rim.
- Marks must be aligned +/- 25mm PRIOR to inflation.
Important:
If a wheel/tire assembly is not within the RFV specification after match mounting, the tire must be returned to the tire manufacturer.
Tire Dismounting and Mounting (Lubricant)
Important:
Lubricant should be applied to form a thin, just visible layer,
on the bead foot and bead outer areas. There should not be any visible
clumps of lubricant.
Ne ...
Tire Inflation Description
When you inflate the tires to the recommended inflation pressures, the factory-installed
wheels and tires are designed in order to handle loads to the tire's rated load
capacity. Incorrect tir ...
Other materials:
Liftgate Window Replacement
Special Tools
BO-24402-A Glass Sealant Remover (Cold Knife)
BO-39032 Stationary Glass Removal Tool
Use an adhesive that is approved by GM
For equivalent regional tools, refer to Special Tools
Removal Procedure
Warning: Refer to Cracked Window Warning.
Note ...
Wiper/Washer System Description and Operation
Wiper/Washer System Components
The wiper/washer system consists of the following electrical components:
Windshield Wiper Relay
Windshield Wiper Speed Control Relay
Windshield Washer Pump Relay
Windshield Washer Pump
Windshield Wiper Motor
Windshield Wiper/Washer Switch
...
Tires and Wheels Description and Operation
There are two types of tire and wheel balancing: static and dynamic.
Static balance is the equal distribution of weight around the wheel. Assemblies
that are statically unbalanced cause a bouncing action called wheel tramp. This
condition may eventually cause uneven tire wear.
...
0.0069