Chevrolet Sonic Repair Manual: Tire Inspection
We recommend that the tires, including the spare tire, if the vehicle has one, be inspected for signs of wear or damage at least once a month.
Replace the tire if:
- The indicators at three or more places around the tire can be seen.
- There is cord or fabric showing through the tire's rubber.
- The tread or sidewall is cracked, cut, or snagged deep enough to show cord or fabric.
- The tire has a bump, bulge, or split.
- The tire has a puncture, cut, or other damage that cannot be repaired well because of the size or location of the damage.
Tire Inflation Description
When you inflate the tires to the recommended inflation pressures, the factory-installed
wheels and tires are designed in order to handle loads to the tire's rated load
capacity. Incorrect tir ...
Tire Pressure Monitor Operation
This vehicle may have a Tire Pressure Monitor System (TPMS). The TPMS is designed
to warn the driver when a low tire pressure condition exists. TPMS sensors are mounted
onto each tire and wheel as ...
Other materials:
Accessory Power Receptacle Replacement
Special Tools
EL-42059 Cigar Lighter Socket Remover .
For equivalent regional tools. Refer to Special Tools
Removal Procedure
Remove the auxiliary power outlet fuse from the fuse block.
Remove the receptacle:
Look into the receptacle. There are two 3?€‰mm ( ...
Rear End Panel Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Warning: Refer to Glass and Sheet Metal Handling Warning.
Note: The rear end lower panel reinforcement extension is
made of Ultra High Strength Dual Phase St ...
Hub/Axle Flange and Wheel Stud Runout Inspection
Special Tools
GE-8001 Dial Indicator Set , or equivalent
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Mark the location of the wheels to the wheel studs and mark the specific
vehicle position on each tire and wheel – LF, LR, RF, RR.
Remove the tire and ...
0.0103