Chevrolet Sonic Owner's Manual: Tire Inspection
We recommend that the tires, including the spare tire, if the vehicle has one, be inspected for signs of wear or damage at least once a month.
Replace the tire if:
- The indicators at three or more places around the tire can be seen.
- There is cord or fabric showing through the tire's rubber.
- The tread or sidewall is cracked, cut, or snagged deep enough to show cord or fabric.
- The tire has a bump, bulge, or split.
- The tire has a puncture, cut, or other damage that cannot be repaired well because of the size or location of the damage.
TPMS Sensor Matching Process
Each TPMS sensor has a unique identification code. The identification code needs
to be matched to a new tire/wheel position after rotating the tires or replacing
one or more of the TPMS sensors. T ...
Tire Rotation
Tires should be rotated every 12 000 km (7,500 mi). See Maintenance Schedule.
Tires are rotated to achieve a uniform wear for all tires. The first rotation
is the most important.
Anytime unusual w ...
Other materials:
Hood Ajar Indicator Description and Operation
Hood Ajar Switch
The body control module (BCM) applies B+ to the hood ajar signal circuit
and monitors the voltage to determine the position of the hood. When the hood
is closed, the switch is open and voltage remains high. When the hood is open,
the switch is closed and the voltag ...
Drive Belt Installation
Special Tools
EN-955 Locking Pins
EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Note: Ensure that the drive belt tensioner is held with EN-955?E
locking pin.
Install the drive belt.
Move the drive belt tensioner clockwise until EN- ...
Main Shaft Disassemble (Gen 2)
Special Tools
69604356 Gear Pullers
For equivalent regional tools, refer to Special Tools.
Remove the 1st gear thrust washer (1) and the 1st gear (2)
using 69604356 pullersand a hydraulic press.
ii
Remove the following components:
1st gear bearing asse ...
0.0047