Range Selector Lever Cable Replacement
Front Wheel Drive Shaft Seal Replacement - Torque Converter Housing SideFog Lamps (RS)
To replace the front fog lamp bulb:
1. Locate the fog lamp located under the front fascia.
2. Remove the cap from the back of the fog lamp assembly.
3. Disconnect the electrical connector from the fog lamp bulb assembly.
4. Remove the bulb by turning it counterclockwise and pulling it straight ...
Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
Pipe Joint Compound
Note: Three types of sealer are commonly used in engines. These
are RTV sealer, anaerobic gasket eliminator sealer, and pipe joint compound.
The correct sealer and amount must be used in the proper location to prevent
oil leaks. DO NOT interchange the 3 ...
Main Shaft Disassemble (Gen 2)
Special Tools
69604356 Gear Pullers
For equivalent regional tools, refer to Special Tools.
Remove the 1st gear thrust washer (1) and the 1st gear (2)
using 69604356 pullersand a hydraulic press.
ii
Remove the following components:
1st gear bearing asse ...