Chevrolet Sonic Repair Manual: Torque Converter Housing with Fluid Pump Assembly Installation (6T30)
|
Callout |
Component Name |
|---|---|
|
1 |
Fluid Pump Seal Assembly |
|
2 |
Torque Converter Housing Gasket |
|
3 |
Torque Converter (w/Fluid Pump) Housing Assembly Note: Rotate the differential slightly in each direction using DT-48277 rotating tool to align the Differential Pinion Gears with the Differential Ring Gear in the Torque Converter Housing. Special Tool
DT-48277 Differential Rotating Tool For equivalent regional tools, refer to Special Tools. |
|
4 |
Torque Converter and Differential Housing Bolts M8 x 30 (Qty: 14) Caution: Refer to Fastener Caution. Procedure
Tighten the bolts in sequence shown. Tighten
10 Y (89 lb in) then rotate the bolt an additional 50 degrees Special Tool
EN-45059 Angle Meter or equivalent For equivalent regional tools, refer to Special Tools. |
Torque Converter Housing Cleaning and Inspection
Torque Converter Housing Cleaning and Inspection
Callout
Component Name
Caution: After cleaning the transmission components, a ...
Torque Converter Housing with Fluid Pump Assembly Installation (6T40/45/50 Non
Hybrid)
Torque Converter Housing with Fluid Pump Assembly Installation
Callout
Component Name
1
Fluid Pump Seal Assembly
...
Other materials:
Radio Frequency Statement
This vehicle has systems that operate on a radio frequency that comply with Part
15 of the Federal Communications Commission (FCC) rules and with Industry Canada
Standards RSS‐GEN/210/220/310.
Operation is subject to the following two conditions:
1. The device may not cause harmful inter ...
Rear Compartment Lid Applique Replacement
Rear Compartment Lid Applique Replacement
Callout
Component Name
Preliminary Procedure
Open and support the rear compartment lid.
Remove the rear compartment lid inner panel trim. Refer to Rear
Compartment Lid Inner Panel ...
Drive Belt Installation
Special Tools
EN-955 Locking Pins
EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Note: Ensure that the drive belt tensioner is held with EN-955?E
locking pin.
Install the drive belt.
Move the drive belt tensioner clockwise until EN- ...
0.0126