Chevrolet Sonic Repair Manual: Torque Converter Housing with Fluid Pump Assembly Installation (6T30)
|
Callout |
Component Name |
|---|---|
|
1 |
Fluid Pump Seal Assembly |
|
2 |
Torque Converter Housing Gasket |
|
3 |
Torque Converter (w/Fluid Pump) Housing Assembly Note: Rotate the differential slightly in each direction using DT-48277 rotating tool to align the Differential Pinion Gears with the Differential Ring Gear in the Torque Converter Housing. Special Tool
DT-48277 Differential Rotating Tool For equivalent regional tools, refer to Special Tools. |
|
4 |
Torque Converter and Differential Housing Bolts M8 x 30 (Qty: 14) Caution: Refer to Fastener Caution. Procedure
Tighten the bolts in sequence shown. Tighten
10 Y (89 lb in) then rotate the bolt an additional 50 degrees Special Tool
EN-45059 Angle Meter or equivalent For equivalent regional tools, refer to Special Tools. |
Fluid Pump Selective Measurement
Fluid Pump Selective Measurement
Callout
Component Name
1
A/Trans Fluid Pump Body
Note: Measure the distance fro ...
Torque Converter Housing with Fluid Pump Assembly Installation (6T40/45/50 Non
Hybrid)
Torque Converter Housing with Fluid Pump Assembly Installation
Callout
Component Name
1
Fluid Pump Seal Assembly
...
Other materials:
Tire Rotation and Required Services Every 12 000 km/ 7,500 mi
Rotate the tires, if recommended for the vehicle, and perform the following services.
See Tire Rotation.
Check engine oil level and oil life percentage. If needed, change engine
oil and filter, and reset oil life system. See Engine Oil and Engine
Oil Life System.
Check engine coo ...
Front Floor Console Multifunction Switch Replacement
Front Floor Console Multifunction Switch Replacement
Callout
Component Name
Preliminary Procedure
Remove the front floor console. Refer to Front Floor Console Replacement
1
Accessory Switch
...
Exhaust Manifold Heat Shield Installation
Install the exhaust manifold heat shield (2).
Caution: Refer to Fastener Caution.
Install the 3 exhaust manifold heat shield bolts (1) and the washers and
tighten to 8 Y (71 lb in).
...
0.0077