|
Callout |
Component Name |
|---|---|
|
1 |
Torque Converter Assembly Note: Failure to lower the torque converter straight down could damage the torque converter clutch lip seal inside the torque converter clutch assembly. Special Tool
DT-46409 Torque Converter Lifting Handles For equivalent regional tools, refer to Special Tools. |
|
2 |
DT-21366 Converter Holding Strap Warning: The torque converter must be held to the torque converter housing by a retaining device such as shipping brackets. Without the retaining device, the torque converter may slide forward, disengaging the oil pump, or may fall completely out of the transmission causing personal injury and/or property damage. |
Torque Converter Housing with Fluid Pump Assembly Removal (Non Hybrid)
Torque Converter RemovalExterior Lighting
The exterior lamp control is on the instrument panel to the outboard side of
the steering column.
O : Briefly turn to this position to turn the automatic light control off or
on again.
AUTO: Turns the headlamps on automatically at normal brightness, together with
the following:
Parking ...
Shifting out of Park (Automatic Transmission)
This vehicle is equipped with a shift lock control. The shift lock control is
designed to:
Prevent ignition key removal unless the shift lever is in P (Park) with
the shift lever button fully released.
Prevent movement of the shift lever out of P (Park) unless the ignition
is in ON/RUN ...
Water Inlet Replacement (LUW)
Removal Procedure
Drain the engine coolant system. Refer to Cooling System Draining and
Filling.
Disconnect the engine coolant temperature sensor connector (1).
Remove the radiator outlet hose connector clip (2) and the radiator
outlet hose ...