Callout |
Component Name |
---|---|
1 |
Lock Pin Warning: Lock pin must be secured into the bench fixture to hold the transmission and prevent bodily injury. Note: Ensure the DT 3289-20 holding fixture is mounted to a bench that is properly supported and will support the weight of the transmission assembly without tipping. DT-39890 holding fixture adapter and an engine stand can be used as an alternative method for supporting the transmission assembly during repairs.
For equivalent regional tools, refer to Special Tools. |
2 |
DT 21366 Torque Converter Holding Strap |
3 |
Torque Converter Assembly Caution: Only install the lift assist handles until it stops. Do not tighten. Over tightening the lift assist handles can cause damage to the torque converter. Note: Failure to raise the torque converter straight up could damage the torque converter clutch lip seal inside the torque converter clutch assembly. Special Tool
DT 46409 Torque Converter Lifting Handles For equivalent regional tools, refer to Special Tools. |
Front Fog Lamp Bulb Replacement
Front Fog Lamp Bulb Replacement
Callout
Component Name
Preliminary Procedure
Remove either the left front or right front wheelhouse liner. Refer
to Front Wheelhouse Liner Replacement.
Disconnect the electrical connector t ...
Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (LUV)
Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement
Callout
Component Name
1
Air Conditioning Refrigerant Pressure Sensor
Caution: Refer to Fastener Caution.
Procedures
Disconnect the air c ...
Fuel Tank Filler Pipe Replacement
Removal Procedure
Remove the bracket fastener (1).
Lift and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove the fuel tank filler pipe bracket fastener (1).
Disconnect the vent hose (2). Refer to
Plastic Collar ...