Callout |
Component Name |
---|---|
Caution: Do not use abrasive pads or bristle devices to clean the sealing surfaces. Abrasive pads produce a fine grit that can effect transmission function. Abrasive pads can also remove enough metal to create oil leaks. Caution: After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure. Caution: Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component.
|
|
1 |
Torque Converter Housing Locating Pin Procedure
Inspect the torque converter housing locating pins. Specification
The locating pins installed height is 7.4 mm (0.29 in). |
2 |
Fluid Trough Check Ball Specification
The check ball installed depth is 11 mm (0.43 in). |
3 |
Converter Housing Sealing Surface |
4 |
Control Valve Body Cover Sealing Surface |
5 |
Fill Cap Seal |
6 |
Transmission Fluid Cooler Pipe Sealing Surface |
7 |
Fluid Pressure Test Plug Caution: Refer to Fastener Caution.
12 Y (106 lb in) |
8 |
Manual Shift Shaft Seal Surface |
9 |
Fluid Fill Cap Sealing Surface |
10 |
Fluid Level Plug Tighten
12 Y (106 lb in) |
11 |
Valve Body Locating Pin Procedure
Inspect the valve body locating pins. Specification
The locating pins installed height is 5.8 mm (0.22 in). |
12 |
Drain Plug Tighten
12 Y (106 lb in) |
Driver or Passenger Seat Back Cushion Frame Replacement
Driver or Passenger Seat Back Cushion Frame Replacement
Callout
Component Name
Preliminary Procedures
Remove the driver or passenger seat. Refer to Driver or Passenger
Seat Removal and Installation
Remove the front seat c ...
Input Speed Sensor Replacement
Removal Procedure
Remove the control solenoid valve and transmission control module assembly.
Refer to Control Solenoid Valve and Transmission Control Module Assembly
Replacement.
Remove the input speed sensor bolt (2) M6 x 23.
Unlock t ...
Transmission Fluid Level and Condition Check
Removal Procedure
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
Remove the front suspension skid plate, if equipped.
Refer to Drivetrain and Front Suspension Frame Skid
Plate Replacement
Place a basin underneath the vehicle.
Clean away all ...