Chevrolet Sonic Repair Manual: Transmission Control Replacement
- Removal Procedure
-
- Remove the floor console. Refer to Front Floor Console Replacement.
- Lift both cable adjustment retainers (1), one for each cable, to release the shift lever and selector lever cable.
- Pull the shift lever and selector lever cable retainers (1) from the transmission control assembly (3).
- Remove the shift lever and selector cable from the shift and selector control
- Remove the 4 transmission control bolts (1).
- Remove the transmission control from the vehicle.
.1
- Installation Procedure
-
- Position the transmission control in the vehicle.
- Install the 4 transmission control bolts (1) and tighten
to 9 Y (80 lb in)
.
- Connect the shift lever and selector lever cables to the shift and selector control adjusters (2).
- Install the shift lever and selector lever cable retainers (1) to the transmission control (3)
- Press down and lock both cable adjustment retainers (1), one for each cable, to adjust the shift lever and selector lever cable.
- Adjust the shift lever and selector level cables. Refer to Manual Transmission Shift Lever Cable Adjustment.
- Install the floor console. Refer to Front Floor Console Replacement.
- Verify the correct operation of the transmission control assembly.
Caution:
Refer to Fastener Caution.
.1
Transmission Control Lever Boot Replacement
Transmission Control Lever Boot Replacement
Callout
Component Name
Preliminary Procedure
Remove the front floor console. Refer ...
Automatic Transmission Shift Lock Control Description and Operation
The automatic transmission park lock control system is a safety device that prevents
an inadvertent shift out of PARK. The driver must press the brake pedal before moving
the park lever out of the ...
Other materials:
Heater and Air Conditioning Evaporator and Blower Module Removal and Installation
Heater and Air Conditioning Evaporator and Blower Module Removal and
Installation
Callout
Component Name
Preliminary Procedures
Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
Drain the cooling sy ...
Camshaft Replacement
Special Tools
EN-422 Installer
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Note: Take extreme care to prevent any scratches, nicks or
damage to the camshafts and caps bearing surfaces.
Remove the timing belt rear cover ( ...
Throttle Body Assembly Installation
Install a NEW throttle body seal.
Install the throttle body (1).
Caution: Refer to Fastener Caution.
Install the 4 throttle body bolts (2) and tighten to
8 Y (71 lb in).
...
0.0057