Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Transmission Disassemble (Gen 2)

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Manual / General / Transmission Disassemble (Gen 2)

Special Tools

For equivalent regional tools, refer to Special Tools.


    Attach R-0007758 holding fixture (2) to the transmission.
  1. Attach R-0007758 holding fixture (2) to the transmission.
  2. Attach R-0007758 holding fixture (2) with transmission to the 3-9506289 Universal Adapter (1).


  3. Remove the clutch release bearing (1).

  4. Remove the clutch fork shaft retaining bolt (2).
  5. Remove the clutch fork shaft (1).

  6. Remove the transmission control lever housing bolts (1).
  7. Remove the control lever housing (2) and gasket (3).

  8. Remove the transmission cover bolts (3).
  9. Remove the transmission cover (2) and gasket (1).

  10. Remove the back up lamp switch (1).

  11. Remove the transmission case bolts (3).
  12. Remove the transmission case (2) and gasket (1).
  13. Remove the case magnet (4), may stay with case.

    14. Note:

    The reverse gear shaft snap ring (6) MUST be installed even if not originally equipped to prevent shifting issues caused by incorrect assembly or parts not in position.

  14. Remove the reverse gear shaft snap ring (6) if equipped.
  15. Remove the reverse idler gear washer (5), may stay on the reverse idler gear shaft.

  16. Mark the differential bearing adjuster and case (1) before removal.

  17. Remove the differential bearing adjuster lock bolt (1).
  18. Remove the differential bearing adjuster lock (2).

  19. Using S-9407198 differential bearing race wrench remove the front differential bearing adjuster (1).
  20. Remove the front differential bearing retainer O-ring seal (2).

  21. Remove the front differential carrier cover bolts (1).
  22. Remove the differential carrier cover (2) and gasket (3).

  23. Remove the front differential carrier (1).
Transmission Disassemble (Gen 1)
Special Tools 3-9506289 Universal Adapter R-0007758 Holding Fixture S-9407198 Differential Bearing Race Wrench For equivalent regional tools, refer to Special Tools. Attach R-0 ...

Transmission Fluid Drain and Fill
Draining Procedure Note: The fluid check bolt at the front of the transmission may not be opened. The transmission fluid drained out during the pre-delivery inspection ...

Other materials:

Interior Care
To prevent dirt particle abrasions, regularly clean the vehicle's interior. Immediately remove any soils. Note that newspapers or dark garments that can transfer color to home furnishings can also permanently transfer color to the vehicle's interior. Use a soft bristle brush to remove d ...

Fog Lamps (RS)
To replace the front fog lamp bulb: Locate the fog lamp located under the front fascia. Remove the cap from the back of the fog lamp assembly. Disconnect the electrical connector from the fog lamp bulb assembly. Remove the bulb by turning it counterclockwise and pulling it straight out ...

Hood Primary Latch Release Cable Handle Replacement
Hood Primary Latch Release Cable Handle Replacement Callout Component Name Preliminary Procedure Remove the front side door opening floor carpet retainer. Refer to Front Side Door Opening Floor Carpet Retainer Replacement. ...

В© 2014-2025 Copyright www.csmans.com
 
0.0573