| Table 1: | Fluid Filter Assembly and Torque Converter Fluid Seal Disassemble |
| Table 2: | Fluid Pump Disassemble |
|
Callout |
Component Name |
|---|---|
|
1 |
Fluid Filter Assembly Note: Rotate filter 90 degrees to disengage locking tangs. |
|
2 |
Torque Converter Fluid Seal Retainer |
|
3 |
Torque Converter Fluid Seal Special Tools
For equivalent regional tools, refer to Special Tools. |
|
4 |
Torque Converter Fluid Seal Assembly Special Tools
For equivalent regional tools, refer to Special Tools. |
|
Callout |
Component Name |
|---|---|
|
Warning: Valve springs can be tightly compressed. Use care when removing retainers and plugs. Personal injury could result. Caution: After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure. Caution: Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component. Preliminary Procedure
Clean and inspect all valve components and the pump body for wear and/or damage. |
|
|
1 |
Fluid Pump Cover Bolts M6 x 25 (Qty: 23) Note: There are 3 bolts on the pump cover side and 20 bolts on the pump body side. |
|
2 |
Fluid Pump Cover |
|
3 |
Fluid Pump Driven Gear |
|
4 |
Fluid Pump Drive Gear |
|
5 |
TCC Control Valve Train |
|
6 |
TCC Blow Off Ball Valve Train |
|
7 |
Pressure Regulator Valve Train |
|
8 |
Fluid Pump Blow Off Ball Valve Train |
|
9 |
A/Trans Fluid Pump Body |
Transmission Fluid Pump Disassemble (6T30)
Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential
Ring Gear Installation (6T30)Roof Rear Header Panel Replacement (5HB)
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Disable the SIR system. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove all ...
Rear Seat Back Bolster Replacement
Rear Seat Back Bolster Replacement
Callout
Component Name
Preliminary Procedures
Disable the SIR system. Refer to SIR Disabling and Enabling
1
Rear Seat Back Cushion Bolster
Warning: Refer t ...
Separating Parts
Note:
Disassembly of the piston, press fit design piston pin, and connecting
rod may create scoring or damage to the piston pin and piston pin bore.
If the piston, pin, and connecting rod have been disassembled, replace the
components as an assembly.
Many internal engine co ...