Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential Ring Gear Installation (6T30)

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential Ring Gear Installation (6T30)



Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential Ring Gear Installation

Callout

Component Name

1

Torque Converter and Differential Housing Seal

2

Fluid Pump Assembly

3

Fluid Pump Bolts M8 x 33 (Qty: 7)

Caution:

Refer to Fastener Caution.

Tighten


10 Y (89 lb in) then rotate the bolt an additional 45 degrees

Special Tool

EN-45059 Angle Meter or equivalent

For equivalent regional tools, refer to Special Tools.

4

Front Differential Carrier Bearing Assembly

5

Front Differential Ring Gear

6

Front Differential Ring Gear Retainer

Note:

Install the retainer with the taper facing away from the ring gear.

7

Front Differential Carrier Baffle

8

Front Differential Carrier Baffle Bolts M6 x 25 (Qty: 2)

Tighten


12 Y (106.21 lb in)

Transmission Fluid Pump Disassemble (6T40/45/50)
Table 1: Fluid Filter Assembly and Torque Converter Fluid Seal Disassemble Table 2: Fluid Pump Disassemble Fluid Filter Assembly and Torque Converter Fluid Seal ...

Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential Ring Gear Installation (6T40/45)
Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential Ring Gear Installation Callout Component Name ...

Other materials:

Removing the Spare Tire and Tools
The compact spare tire and tools are located in the storage compartment in the rear of the vehicle. The jack and tools are stored below the spare tire. 1. Extension 2. Jack 3. Wheel Wrench 4. Strap To access the spare tire and tools: 1. Open the trunk or liftgate. See Trunk (Sedan)  o ...

Camber Description
Camber is the tilting of the wheels from the vertical when viewed from the front of the vehicle. When the wheels tilt outward at the top, the camber is positive (+). When the wheel tilts inward at the top, the camber is negative (−). The amount of tilt is measured in degr ...

Engine Front Cover and Oil Pump Disassemble
Engine Front Cover Disassemble Remove the intake camshaft position sensor bolt (1). Remove the intake camshaft position sensor (2) and the seal ring (3). Remove the exhaust camshaft position sensor bolt (6). Remove the exhaust camshaft posi ...

В© 2014-2022 Copyright www.csmans.com
 
0.006