The following transmission-related indicators and messages may be displayed on the Instrument Panel Cluster (IPC). For a complete listing and description of all vehicle indicators and messages, refer to Indicator/Warning Message Description and Operation.
This message is displayed when the TCM detects a transmission fluid temperature (TFT) equal to or greater than 132?C (270?F) for 5 seconds.
This message displays when there is a problem with the transmission.
Transmission Identification Information
Transmission Rear Mount Bracket ReplacementCrankshaft Balancer Removal
Special Tools
EN-652 Flywheel Holder
For equivalent regional tools, refer to Special Tools.
Install the EN-652 holder (1). Lock the flywheel (2) or the automatic
transmission flex plate via the starter ring gear.
Remove and DISCARD the crankshaft balancer bo ...
Piston, Connecting Rod, and Bearing Installation
Special Tools
EN-470-B Angular Torque Wrench
For equivalent regional tools, refer to Special Tools.
Adjust the piston ring joints as follows:
Upper compression ring (1).
Lower compression ring (4).
Oil rings (2) or (3).
Oil ring spacer (5). ...
Ignition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Coil
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the engine wiring harness guide (1) from the cylinder head.
Disconnect the ignition coil electrical connector (2).
...