Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Transmission Mount Bracket Replacement - Left Side

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Manual / General / Transmission Mount Bracket Replacement - Left Side

Removal Procedure
  1. Remove the left transmission mount. Refer to Transmission Mount Replacement - Left Side.


  2. Remove the three left transmission mount bracket to transmission bolts (1).
  3. Remove the left transmission mount bracket (2) from the transmission.
Installation Procedure

    Install the left transmission mount bracket (2) to
  1. Install the left transmission mount bracket (2) to the transmission.
  2. Caution:

    Refer to Fastener Caution.

  3. Install the left transmission mount bracket to transmission bolts (1) and tighten to 62 Y (46 lb ft)

    .

  4. Install the left transmission mount. Refer to Transmission Mount Replacement - Left Side.
Transmission Identification Information
mmmmmmmmmmm1c The code for the M32-6 transmission will be found on the back of the transmission housing, above the axle shaft. In addition, an Alphacode sticker will be placed on the cover of t ...

Transmission Mount Bracket Replacement - Rear
Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the front suspension skid plate, if equipped. Refer to Drivetrain and Front Su ...

Other materials:

Hood Replacement
Hood Replacement Callout Component Name Preliminary Procedure Disconnect the windshield washer nozzle hose. 1 Hood Hinge Nut (Qty:?€‰4) Caution: Refer to Fastener Caution. Procedu ...

Crankcase Ventilation System Inspection/Diagnosis
Results of Incorrect Operation A plugged positive crankcase ventilation (PCV) orifice or hose may cause the following conditions: Rough idle Stalling or slow idle speed Oil leaks Oil in the throttle body Sludge in the engine Functional Check With thes ...

Valve Guide Reaming, and Valve and Seat Grinding
Valve Cleaning Procedure Use soft bristle wire brush to clean any carbon build-up from the valve head. DO NOT use a wire brush on any part of the valve stem. The valve stem is chrome plated to provide enhanced wear characteristics. Wire brushing the stem could remove the chr ...

© 2014-2026 Copyright www.csmans.com
 
0.0073