Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Transmission Mount Bracket Replacement - Rear

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / Transmission Mount Bracket Replacement - Rear

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Using a suitable jack stand, support the rear of the transmission.

  3. Remove and DISCARD the rear transmission mount bracket to rear mount through bolt (1).

  4. Remove and DISCARD the 3 rear transmission mount bracket to transmission bolts (1).
  5. Remove the rear transmission mount bracket (2).
Installation Procedure

    Install the rear transmission mount bracket (2).
  1. Install the rear transmission mount bracket (2).
  2. Caution:

    Refer to Fastener Caution.

  3. Install the 3 NEW rear transmission mount bracket to transmission bolts (1) and tighten to 100 Y (74 lb ft) plus 30?5 degrees

    .



  4. Install the NEW rear transmission mount bracket to rear mount through bolt (1) and tighten to 80 Y (59 lb ft) plus 45?0 degrees

    .

  5. Remove the jack stand.
  6. Lower the vehicle.
Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential Ring Gear Removal (6T40/45)
Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential Ring Gear Removal Callout Component Name 1 ...

Transmission Mount Replacement - Left Side
Removal Procedure Remove the battery tray. Refer to Battery Tray Replacement. Install the engine support fixture. Refer to Engine Support Fixture. Remove and DIS ...

Other materials:

If No Steam Is Coming from the Engine Compartment
If an engine overheat warning is displayed but no steam can be seen or heard, the problem may not be too serious. Sometimes the engine can get a little too hot when the vehicle: Climbs a long hill on a hot day. Stops after high-speed driving. Idles for long periods in traffic. If the ...

Sunroof Window Seal Replacement
Removal Procedure Remove the sunroof window panel. Refer to Sunroof Window Replacement. Remove the seal from the window panel frame by pulling the seal away at one point and continuing around the perimeter of the frame. Clean around the edge of the inside surf ...

Crankshaft Rear Oil Seal Installation
Special Tools EN-658-1 Installer EN-235-6 Installer For equivalent regional tools, refer to Special Tools. Slide the crankshaft rear oil seal (2) across the EN-235-6 installer (1). Install the crankshaft rear oil seal (1) with EN-235-6 installer ...

В© 2014-2022 Copyright www.csmans.com
 
0.0068