Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Transmission Mount Bracket Replacement - Rear

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Transmission Mounts / Transmission Mount Bracket Replacement - Rear

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.
  3. Using a suitable jack stand, support the rear of the powertrain.

  4. Remove and DISCARD the transmission rear mount to bracket through bolt (1).

  5. Remove and DISCARD the transmission rear mount bracket bolts (1).
  6. Remove the transmission rear mount bracket (2).
Installation Procedure

    Install the transmission rear mount bracket (2).
  1. Install the transmission rear mount bracket (2).
  2. Caution:

    Refer to Fastener Caution.

  3. Install the NEW transmission rear mount bracket bolts (1) and tighten to 100 Y (74 lb ft) plus 30?5 degrees

    .



  4. Install the NEW transmission rear mount to bracket through bolt (1) and tighten to 80 Y (59 lb ft) plus 45?0 degrees

    .

  5. Remove the jack stand.
  6. Install the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.
  7. Lower the vehicle.
Transmission Mount Bracket Replacement - Left Side
Removal Procedure Remove the left transmission mount. Refer to Transmission Mount Replacement - Left Side. Remove the three left transmission mount bracket to tr ...

Transmission Mount Replacement - Left Side
Removal Procedure Remove the battery tray. Refer to Battery Tray Replacement. Install the engine support fixture. Refer to Engine Support Fixture. Remove and DIS ...

Other materials:

Horns System Description and Operation
System Description The horn system consists of the following components: HORN fuse Underhood fuse block (contains PCB horn relay) Horn switch Horn Body control module (BCM) K84Keyless Entry Control ModuleS33Horn SwitchK73Telematics Communication In ...

Rear Compartment Lid Nameplate Replacement (Sedan)
Rear Compartment Lid Nameplate Replacement Callout Component Name 1 Rear Compartment Lid Nameplate Caution: Refer to Exterior Trim Emblem Removal Caution. Procedure The part and surface should be ...

Engine Control Module Replacement
Engine Control Module Replacement Callout Component Name Note: If the ECM is to be replaced, the ECM must be RESET (prepared for removal) prior to removal from the vehicle. Failing to reset the ECM will result in the ...

В© 2014-2024 Copyright www.csmans.com
 
0.0066