Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Transmission Rear Mount Bracket Replacement

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Manual / General / Transmission Rear Mount Bracket Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.
  3. Using a suitable jack stand, support the rear of the powertrain.

  4. Remove and DISCARD the transmission mount to bracket through bolt (1).

  5. Remove and DISCARD the transmission mount bracket bolts (1).
  6. Remove the transmission rear mount bracket (2).
Installation Procedure

    Install the transmission rear mount bracket (2).
  1. Install the transmission rear mount bracket (2).

    2. Caution:

    Refer to Fastener Caution.

  2. Install the NEW transmission mount bracket bolts (1) and tighten to 100 Y (74 lb ft) plus 30-45 degrees

    .



  3. Install the NEW transmission mount to bracket through bolt (1) and tighten nut to 80 Y (59 lb ft) plus 45-60 degrees

    .

  4. Remove the jack stand.
  5. Install the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.
  6. Lower the vehicle.
Transmission Mount Replacement - Left Side
Removal Procedure Remove the battery tray. Refer to Battery Tray Replacement. Install the engine support fixture. Refer to Engine Support Fixture. Remove and DIS ...

Transmission Rear Mount Replacement
Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Using a suitable jack stand, support the rear of the powertrain. Remove a ...

Other materials:

Front Fender Replacement
Front Fender Replacement Callout Component Name Preliminary Procedures Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. Remove the headlamp. Refer to Headlamp Replacement. Remove the front whe ...

Crankshaft and Bearing Removal
Identify all the connecting rod bearing caps (1). Remove the 4 bolts. Remove the connecting rod bearing caps 1 and 4 (1). Turn the crankshaft through 180°. Remove the 4 bolts. Remove the connecting rod bearing caps 2 and 3 ( ...

Exhaust Rear Muffler Heat Shield Replacement
Exhaust Rear Muffler Heat Shield Replacement Callout Component Name Preliminary Procedure Disconnect the exhaust system hangers in the rear and allow the exhaust system to rest on the rear axle. 1 ...

© 2014-2025 Copyright www.csmans.com
 
0.0055