Chevrolet Sonic Repair Manual: Transmission Rear Mount Replacement
- Removal Procedure
-
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove and DISCARD the rear transmission mount bracket to rear mount through bolt (1).
- Remove rear transmission mount to frame bolt (3).
- Push and hold the powertrain assembly forward and then remove rear transmission mount.
- Installation Procedure
-
- Push and hold the powertrain assembly forward and then install rear transmission mount.
- Install rear transmission mount to frame bolt (3)
and tighten to 100 Y (74 lb ft)
.
- Install the NEW rear transmission mount bracket to
rear mount through bolt (1) and tighten to 80 Y
(59 lb ft) plus 45?0 degrees
.
- Lower the vehicle.
Caution:
Refer to Fastener Caution.
Transmission Rear Mount Bracket Replacement
Removal Procedure
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove the front suspension skid plate, if equipped.
Refer to Drivetrain and Front Su ...
Transmission Replacement
Removal Procedure
Remove the battery and battery tray. Refer to
Battery Tray Replacement.
Disconnect the transmission range selector lever cable
terminal (1) ...
Other materials:
Hood Side Seal Replacement
Hood Side Seal Replacement
Callout
Component Name
1
Hood Side Seal Push-In Retainer (Qty:?€‰6)
2
Hood Side Seal
...
Front Side Door Upper Front Trim Panel Replacement
Front Side Door Upper Front Trim Panel Replacement
Callout
Component Name
1
Front Side Door Upper Front Trim Panel Assembly
Procedure
Use the appropriate plastic trim tool to aid in the removal of the door
tri ...
Engine Flywheel Installation
Special Tools
EN-652 Flywheel Holder
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools.
Clean the thread in the crankshaft.
Install the crankshaft position reluctor ring (1).
Install the flywheel (2).
Install the EN-652 ...
0.0049