Chevrolet Sonic Repair Manual: Transmission System Description and Operation
The F17 is a 5 speed manual transmission assembly.
Note:
Use only transmission fluid listed within the Adhesives, Fluids, Lubricants, and Sealers for this manual transmission assembly. Other lubricants or additives may affect the shift performance.
The F17 (Gen 1) 5 Speed manual transmission has the following features:
- First and second gear double coned synchronizer
- Third, fourth, and fifth gear single coned synchronizer
- Two shaft design consisting of an input shaft, and main shaft
- Reverse inhibit feature
- One piece clutch actuator ?no bleed screw
- Transmission venting system is part of the fill cap
- Vehicle speed sensor (VSS)
The F17 (Gen 2) 5 Speed manual transmission has the following features:
- First, second, third, and fourth gear double coned synchronizer
- Fifth gear single coned synchronizer
- Two shaft design consisting of an input shaft, and main shaft
- Synchronized Reverse Gear
- One piece clutch actuator ?no bleed screw
- Transmission venting system is part of the fill cap
- Vehicle speed sensor (VSS)
The manual transmission shift cables must be adjusted for proper shifter performance.
Transmission Replacement (With 1.6L or 1.8L Engine)
Removal Procedure
Remove the battery tray. Refer to
Battery Tray Replacement.
Without draining the coolant or removing the hoses,
remove and position aside the radiator surge t ...
Vehicle, Engine and Transmission ID and VIN Location, Derivative and Usage
The vehicle identification number (VIN) plate is the legal identifier of the
vehicle. The VIN plate is located on the upper left corner of the instrument panel
(I/P) and can be seen through th ...
Other materials:
Rear Wheelhouse Panel Liner Extension Replacement
Rear Wheelhouse Panel Liner Extension Replacement
Callout
Component Name
Preliminary Procedure
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and
Installation.
1
Rear Wheelh ...
Toe Description
Toe is a measurement of how much the front and/or rear wheels are turned in or
out from a straight-ahead position. When the wheels are turned in, toe is positive (+).
When the wheels are turned out, toe is negative (−). The actual amount of toe is
normally only a fraction ...
Throttle Body Heater Inlet Pipe Replacement (LUW)
Throttle Body Heater Inlet Pipe Replacement
Callout
Component Name
Preliminary Procedure
Drain the cooling system. Refer to Cooling System
Draining and Filling.
1
Throttle Body Heater Inlet Pipe ...
0.0053