Chevrolet Sonic Repair Manual: Turbocharger Oil Feed Pipe Replacement
- Removal Procedure
-
- Open the hood.
- Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement.
- Remove the turbocharger oil feed pipe bolt (5).
- Remove the turbocharger oil feed pipe hollow screw (4) and the 2 seal rings (1) and (3).
- Remove the turbocharger oil feed pipe (2) and the rubber seal ring.
- Installation Procedure
-
- Clean the sealing surfaces.
- Install the turbocharger oil feed pipe (2) along with a NEW rubber seal ring.
- Install the turbocharger oil feed pipe hollow screw (4) and 2 NEW seal rings (1) and (3).
- Install the turbocharger oil feed pipe bolt (5) and tighten to 10 Y (89 lb in)
.
- Tighten the turbocharger oil feed pipe hollow screw to 30 Y (22 lb ft)
.
- Install the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement.
- Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
- Close the hood.
Caution:
Refer to Fastener Caution.
Turbocharger Installation
Special Tool
EN-49942 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces.
Replace the connect fittings on the turbocharger coolant feed pipe an ...
Turbocharger Oil Return Pipe Replacement
Removal procedure
Remove the drivetrain and front suspension frame skid plate, if equipped.
Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.
...
Other materials:
Backup Lamp Bulb Replacement (Sedan)
Backup Lamp Bulb Replacement
Callout
Component Name
Preliminary Procedure
Remove the tail lamp assembly. Refer to Tail Lamp Replacement.
1
Back Up Lamp Bulb Socket
Procedure
Rotate the back u ...
Cleanliness and Care
An automobile engine is a combination of many machined, honed, polished, and
lapped surfaces with tolerances that are measured in ten thousandths of an inch.
When any internal engine parts are serviced, care and cleanliness are important.
A liberal coating of engine oil should be applied to fr ...
Air Cleaner Inlet Duct Replacement
Removal Procedure
Remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner
Replacement.
Remove the upper intake air duct plastic fastener (1).
Pull the lower portion of the intake air duct outward to release the
duct from the rub ...
0.0056