Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Turbocharger Oil Return Pipe Replacement

Removal procedure
  1. Remove the drivetrain and front suspension frame skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.


  2. Note:

    Simplified Graphic. DO NOT remove the warm up three way catalytic converter.

  3. Remove the 2 turbocharger oil return pipe bolts (1).
  4. Place a drain pan below the vehicle.
  5. Release the turbocharger oil return pipe connector (4) and disconnect the turbocharger oil return pipe from the engine block.
  6. Remove the turbocharger oil return pipe (2) and the gasket (3).
Installation Procedure
  1. Clean the sealing surfaces.

  2. Install the turbocharger oil return pipe (2) in compound with a NEW gasket (3) and connect to the engine block.
  3. Caution:

    Refer to Fastener Caution.

  4. Install the 2 turbocharger oil return pipe bolts (1) and tighten to  8 Y (71 lb in)

    .

  5. Lower the vehicle.
  6. Check engine oil level.
  7. Install the drivetrain and front suspension frame skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.
Turbocharger Oil Feed Pipe Replacement
Removal Procedure Open the hood. Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the exhaust manifold heat shield. Refer ...

Turbocharger Removal
Special Tool EN-49942 Holding Wrench For equivalent regional tools, refer to Special Tools. Install the EN-49942 holding wrench  (2) to the turbocharger coolant feed pipe. Guid ...

Other materials:

Passenger Sensing System
The vehicle has a passenger sensing system for the front outboard passenger position. The passenger airbag status indicator will light on the instrument panel when the vehicle is started. United States Canada The words ON and OFF, or the symbol for on and off, will be visible during the ...

Ball Joint Inspection
Caution: Refer to Vehicle Lifting and Jacking Caution. Raise the front of the vehicle to allow the front suspension to hang free. Grasp the tire at the top and the bottom. Move the top of the tire in an in-and-out motion. Look for any horizontal movement of the knuckle relativ ...

Fuel Injector Replacement
Fuel Injector Replacement Callout Component Name Preliminary Procedure Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the fuel injection fuel rail assembly. Refer t ...

В© 2014-2024 Copyright www.csmans.com
 
0.0147