Chevrolet Sonic Owner's Manual: Turning the Systems Off and On

Chevrolet Sonic Owner's Manual / Driving and Operating / Ride Control Systems / System Operation / Turning the Systems Off and On

The button for TCS and StabiliTrak is on the center console.

Caution

Do not repeatedly brake or accelerate heavily when TCS is off. The vehicle driveline could be damaged.

To turn off only TCS, press and release the button. The traction off light
To turn TCS on again, press and release the displays in the instrument cluster.

To turn TCS on again, press and release the button. The traction off light
displayed in the instrument cluster
will turn off.

If TCS is limiting wheel spin when the button is pressed, the system will
not turn off until the wheels stop spinning.

To turn off both TCS and StabiliTrak, press and hold the button until the traction off light
and StabiliTrak OFF Light
come on and stay on in the instrument
cluster.

To turn TCS and StabiliTrak on again, press and release the button. The traction off light
and StabiliTrak OFF Light
Adding accessories can affect the vehicle performance. See Accessories and Modifications. in the instrument cluster turn off.

Adding accessories can affect the vehicle performance. See Accessories and Modifications.

System Operation

The vehicle has a Traction Control System (TCS) and StabiliTrak®, an electronic stability control system. These systems help limit wheel slip and assist the driver in maintaining control, especia ...

Cruise Control

If the vehicle is equipped with cruise control, a speed of about 40 km/h (25 mph) or more can be maintained without keeping your foot on the accelerator. Cruise control does not work at speeds bel ...

Other materials:

Rear Seats
Folding the Seatback Either side of the seatback can be folded down for more cargo space. Fold a seatback only when the vehicle is not moving. Caution Folding a rear seat with the safety belts still fastened may cause damage to the seat or the safety belts. Always unbuckle the safety belts an ...

Sunroof Motor/Actuator Initialization/Teach Process
Note: If the sunroof motor is new, cycle the sunroof seven?€‰(7) times to teach the motor/actuator initialization process. Perform the initialization/teach procedure on a reinstall motor or a new motor. Ensure the electrical harness on the headliner is connected to the sunroof mot ...

Front Wheel Drive Shaft Replacement
Special Tools J-45859 Axle Remover For regional equivalent tools, refer to Special Tools. Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the front suspension skid plate bolts (1) and the front suspen ...

0.0064