Chevrolet Sonic Owner's Manual: Underbody Maintenance
At least twice a year, Spring and Fall, use plain water to flush dirt and debris from the vehicle's underbody. Your dealer or an underbody car washing system can do this. If not removed, rust and corrosion can develop.
Body Component Lubrication
Lubricate all key lock cylinders, hood hinges, liftgate hinges, and the fuel
door hinge unless the components are plastic. Applying silicone grease on weatherstrips
with a clean cloth will make th ...
Sheet Metal Damage
If the vehicle is damaged and requires sheet metal repair or replacement, make
sure the body repair shop applies anti-corrosion material to parts repaired or replaced
to restore corrosion protecti ...
Other materials:
Steering Angle Sensor Centering
The steering angle sensor does not require centering often. Centering of the
steering angle sensor might be required after certain service procedures are performed.
Some of these procedures are as follows:
Wheel alignment
Steering gear replacement
Steering column replacement
Collision ...
Crankshaft Front Oil Seal Installation
Special Tools
EN-6351 Mounting Sleeves
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces.
Slide the EN-6351 sleeves (2) protective sleeve onto the crankshaft
journal.
Slide the crankshaft front oil seal (1) over the protective sleev ...
System maintenance
Example
Basic information
The two radar sensors A for the I-BSI system are located near the rear bumper.
Always keep the area near the radar sensors clean.
The radar sensors may be blocked by temporary ambient conditions such as snow,
splashing water, mist or fog.
The blocked condition ma ...
0.0058