Do not pump the brakes. Just hold the brake pedal down firmly and let ABS work. You might hear the ABS pump or motor operating and feel the brake pedal pulsate, but this is normal.
Antilock Brake System (ABS)
Braking in EmergenciesRoof Panel Joint Finish Molding Replacement
Roof Panel Joint Finish Molding Replacement
Callout
Component Name
Caution: Refer to Exterior Trim Emblem Removal Caution.
Preliminary Procedures
Begin at the rear edge of the roof panel joint finish molding an ...
Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration
software. The module stores and utilizes this information however if it is not properly
configured with the correct calibration software, the seat heating control module
will not control all of the vehicle features ...
Starter Replacement (LUV)
Removal Procedure
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnection and Connection.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
If equipped with a front suspension skid plate, remove the drivetrain
...