Chevrolet Sonic Owner's Manual: Using the Outside Mirror with the Blind Spot Mirror
1. Set the main mirror so that the side of the vehicle can just be seen and the blind spot mirror has an unobstructed view.
2. When checking for traffic or before changing a lane, look at the main driver/passenger side mirror to observe traffic in the adjacent lane, behind your vehicle. Check the blind spot mirror for a vehicle in the blind zone. Then, glance over your shoulder to double check before moving slowly into the adjacent lane.
Driving with the Blind Spot Mirror
Actual Mirror View
1. When the approaching vehicle is a long distance away, the image in the main
mirror is small and near the inboard edge of the mirror.
2. As the vehicle gets closer, the imag ...
Interior Mirrors
Manual Rearview Mirror
Hold the inside rearview mirror in the center to move it for a clearer view behind
your vehicle. Adjust the mirror to avoid glare from the headlamps behind you. Push
the ta ...
Other materials:
Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
Sedan Taillamp Shown, Hatchback Taillamp Similar
Back-up Lamp
Turn Signal Lamp
Stop Lamp/Taillamp
Sidemarker Lamp
To replace one of these bulbs:
Open the trunk.
Remove the two screws, which secure the taillamp assembly.
Remove the taillamp assembly by pulling it straight ...
Front Wheel Drive Intermediate Shaft Replacement
Front Wheel Drive Intermediate Shaft Replacement
Callout
Component Name
Preliminary Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the wheel drive shaft assembly from the vehicle ...
Reverse (Gen 2)
When the gear selector lever is moved to the Reverse (R) position (from the Park
position) the normally-low 35R pressure control solenoid is commanded ON and the
following changes occur in the transmission? hydraulic and electrical systems:
3-5-Reverse Clutch Applies
Manual Valve
...
0.0048