Special Tool
EN-845 Suction Device
For equivalent regional tools, refer to Special Tools.
Note:
Observe the correct locations.
Note:
Coat the sliding surfaces with NEW engine oil.
Install the 16 valve lifter (1), using the EN-845 suction device .
Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
Valve Lifter RemovalStationary Window Waterleak Repair
Warning: If any water enters the vehicle interior up to the level
of the carpet or higher and soaks the carpet, the sensing and diagnostic module
(SDM) and the SDM harness connector may need to be replaced. The SDM could be
activated when powered, which could cause deployment of the air ...
Rear Seat Cushion Removal and Installation
Rear Seat Cushion Removal and Installation
Callout
Component Name
1
Rear Seat Cushion Replacement
Procedure
Release the rear seat center seat belts.
Lift up on the front of the seat cushion at the latch locati ...
Charge Air Cooler Outlet Air Hose Replacement
Removal Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
Loosen the clamp (1) at the charge air cooler outlet pipe (2) to throttle
body (3).
Disconnect the intake air pressure and temperature sensor harness connect ...