Chevrolet Sonic Repair Manual: Valvetrain Timing
- Camshaft Timing Chain Adjustment
- Camshaft Timing Chain Inspection
- Camshaft Timing Chain Installation
- Camshaft Timing Chain Removal
- Camshaft Timing Chain Replacement
- Timing Belt Adjustment
- Timing Belt Center Front Cover Installation
- Timing Belt Center Front Cover Removal
- Timing Belt Center Front Cover Replacement
- Timing Belt Inspection
- Timing Belt Installation
- Timing Belt Lower Front Cover Installation
- Timing Belt Lower Front Cover Removal
- Timing Belt Lower Front Cover Replacement
- Timing Belt Rear Cover Installation
- Timing Belt Rear Cover Removal
- Timing Belt Rear Cover Replacement
- Timing Belt Removal
- Timing Belt Replacement
- Timing Belt Upper Front Cover Installation
- Timing Belt Upper Front Cover Removal
- Timing Belt Upper Front Cover Replacement
- Timing Belt Idler Pulley Installation
- Timing Belt Idler Pulley Removal
- Timing Belt Idler Pulley Replacement
- Timing Belt Tensioner Installation
- Timing Belt Tensioner Removal
- Timing Belt Tensioner Replacement
- Timing Chain Tensioner Installation
- Timing Chain Tensioner Removal
- Timing Chain Tensioner Replacement
Camshaft Sprocket Replacement
Special Tools
EN-6340 Camshaft Adjuster Locking Tool
EN-6628–A Camshaft Locking Tool
EN-45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
Removal Procedure
...
Camshaft Timing Chain Adjustment
Special Tools
EN-952 Fixing Pin
EN-953–A Fixing Tool
EN-49977?E00 Fixation Sensor Discs
For equivalent regional tools, refer to Special Tools.
Remove the ignition coil. Refer to Ign ...
Other materials:
Antilock Brake System (ABS) Warning Light
This light comes on briefly when the engine is started.
If the light stays on, turn the ignition to LOCK/OFF or if the light comes on,
stop as soon as possible and turn the ignition off. Then start the engine again
to reset the system. If the light still stays on, or comes on again while driv ...
Reverse (Gen 1)
When the gear selector lever is moved to the Reverse (R) position (from the Park
position) the normally-high 35R pressure control solenoid 2 is commanded ON and
the following changes occur in the transmission? hydraulic and electrical systems:
3-5-Reverse Clutch Applies
Manual Valv ...
Transmission Mount Bracket Replacement - Rear
Removal Procedure
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove the front suspension skid plate, if equipped.
Refer to Drivetrain and Front Suspension Frame Skid
Plate Replacement.
Using a suitable jack stand, support the rear of the ...
0.0078