Chevrolet Sonic Owner's Manual: Vehicle Care
- General Information
- General Information
- California Proposition 65 Warning
- California Perchlorate Materials Requirements
- Accessories and Modifications
- Vehicle Checks
- Doing Your Own Service Work
- Hood
- Engine Compartment Overview
- Engine Oil
- Engine Oil Life System
- Automatic Transmission Fluid
- Manual Transmission Fluid
- Hydraulic Clutch
- Engine Air Cleaner/Filter
- Cooling System
- Engine Coolant
- Engine Overheating
- Washer Fluid
- Brakes
- Brake Fluid
- Battery
- Starter Switch Check
- Automatic Transmission Shift Lock Control Function Check
- Ignition Transmission Lock Check
- Park Brake and P (Park) Mechanism Check
- Wiper Blade Replacement
- Headlamp Aiming
- Bulb Replacement
- Bulb Replacement
- Halogen Bulbs
- Headlamps, Front Turn Signal and Parking Lamps
- Fog Lamps (LS, LT, and LTZ)
- Fog Lamps (RS)
- Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
- License Plate Lamp
- Replacement Bulbs
- Electrical System
- Electrical System Overload
- Fuses and Circuit Breakers
- Engine Compartment Fuse Block
- Instrument Panel Fuse Block
- Wheels and Tires
- Tires
- All-Season Tires
- Winter Tires
- Summer Tires
- Tire Sidewall Labeling
- Tire Designations
- Tire Terminology and Definitions
- Tire Pressure
- Tire Pressure Monitor System
- Tire Pressure Monitor Operation
- Tire Inspection
- Tire Rotation
- When It Is Time for New Tires
- Buying New Tires
- Different Size Tires and Wheels
- Uniform Tire Quality Grading
- Wheel Alignment and Tire Balance
- Wheel Replacement
- Tire Chains
- If a Tire Goes Flat
- Tire Sealant and Compressor Kit
- Storing the Tire Sealant and Compressor Kit
- Tire Changing
- Compact Spare Tire
- Jump Starting
- Towing the Vehicle
- Appearance Care
Conversions and Add-Ons
Add-On Electrical Equipment
Caution
Some electrical equipment can damage the vehicle or cause components to not
work and would not be covered by the warranty. Always check with your dealer before ...
Other materials:
Lock Cylinder Coding - Ignition
The ignition lock cylinder uses 8 key cut positions, 1–8. The ignition cylinder
tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in
and are not self-retaining. It follows the key code with the first tumbler being
the first depth of the ...
Rear Wheel Bearing and Hub Replacement (Drum Brake)
Rear Wheel Bearing and Hub Replacement
Callout
Component Name
Preliminary Procedures
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Rem ...
Engine Oil Cooler Installation
Note: Lubricate the oil cooler seal (8) with clean engine oil.
Install the engine oil cooler assembly (6) along with 2 NEW sealings (8)
and (9).
Install the 3 oil cooler bolts (5) and tighten to 10 Y (89 l ...
0.0065