Accessories and Modifications
Doing Your Own Service WorkIgnition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Coil
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the engine wiring harness guide (1) from the cylinder head.
Disconnect the ignition coil electrical connector (2).
...
Intake Manifold Disassemble
Remove the fuel injection rail ground cable nut (1).
Remove the 2 fuel injection rail bolts (2).
Remove the fuel injection fuel rail assembly (3).
Remove the intake manifold gasket (4).
Remove the 2 manifold absolute pressure sensor bolts ...
Thrust Washer and Bearing Cleaning and Inspection
Warning: Wear safety glasses to avoid injury when using compressed
air or any cleaning solvent. Bodily injury may occur if fumes are inhaled
or if skin is exposed to chemicals.
Caution: Do not allow the bearings to spin. Turn them slowly by
hand. Spinning the beari ...