Chevrolet Sonic Repair Manual: Vehicle Yaw Sensor Learn
The yaw sensor does not require calibration often. Calibration of the yaw rate sensor might be required after certain service procedures are performed. Some of these procedures are as follows:
- Electronic brake control module (EBCM) replacement
- Multi-axis acceleration sensor replacement
The yaw rate sensor calibration procedure can be completed with a scan tool using the following steps:
- Place vehicle on a level surface.
- Apply the parking brake, or set the transmission in the park position.
- Install the scan tool to the data link connector.
- Turn the ignition ON, and the engine OFF.
- Select Yaw Rate Sensor Reset in the Multi-axis Acceleration Sensor Module Control Functions list.
- Follow the scan tool directions to complete the calibration procedure.
- Select Yaw Rate Sensor Learn in the Multi-axis Acceleration Sensor Module Control Functions list.
- Follow the scan tool directions to complete the calibration procedure.
- Clear any DTCs that may be set.
Steering Angle Sensor Centering
The steering angle sensor does not require centering often. Centering of the
steering angle sensor might be required after certain service procedures are performed.
Some of these procedures are as ...
Vehicle Yaw Sensor Replacement
Vehicle Yaw Sensor Replacement
Callout
Component Name
Preliminary Procedures
Turn the ignition OFF.
Remove the front floor cons ...
Other materials:
Radio Windshield Side Garnish Molding Speaker Replacement
Radio Windshield Side Garnish Molding Speaker Replacement
Callout
Component Name
Preliminary Procedure
Remove the windshield side garnish molding. Refer to
Windshield Side Garnish Molding Replacement.
1
...
Battery Description and Operation
Warning: Batteries produce explosive gases, contain corrosive acid,
and supply levels of electrical current high enough to cause burns. Therefore,
to reduce the risk of personal injury when working near a battery:
Always shield your eyes and avoid leaning over the battery whenever
...
Fluid Pump Selective Measurement
Fluid Pump Selective Measurement
Callout
Component Name
1
A/Trans Fluid Pump Body
Note: Measure the distance from the bottom of a gauge bar
to the bottom of the pump rotor cavity. Refer to
Fluid Pump Sel ...
0.0127