Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Vehicle Yaw Sensor Replacement



Vehicle Yaw Sensor Replacement

Callout

Component Name

Preliminary Procedures

  1. Turn the ignition OFF.
  2. Remove the front floor console. Refer to Front Floor Console Replacement.

1

Yaw Sensor Nut

Caution:

Refer to Fastener Caution.

Tighten


9 Y (80 lb in)

2

Vehicle Yaw Sensor with Vehicle Lateral and Longitudinal Accelerometer

Procedure

  1. After the installation is complete, configure the yaw sensor. Refer to Control Module References.
  2. After the installation is complete, perform the Vehicle Yaw Sensor Learn.
Vehicle Yaw Sensor Learn
The yaw sensor does not require calibration often. Calibration of the yaw rate sensor might be required after certain service procedures are performed. Some of these procedures are as follows: ...

Sensors
...

Other materials:

Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange, remeasure the tire and wheel assembly on-vehicle runout in order to verify that the amount of runout has been reduced and brought to within tolerances. Mark the location of the high spot on the tire and wheel asse ...

Evaporative Emission System Hose/Pipe Replacement
Special Tools CH-807 Closure Plugs CH-6015 Closure Plugs For equivalent regional tools, refer to Special Tools. Removal Procedure Warning: Refer to Gasoline/Gasoline Vapors Warning. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnec ...

Transmission Rear Mount Bracket Replacement
Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement. Using a suitable jack stand, support the rear of the ...

В© 2014-2026 Copyright www.csmans.com
 
0.0059