Chevrolet Sonic Repair Manual: Warm Up Three-Way Catalytic Converter Removal
- Disconnect the heated oxygen sensor wiring harness (3) from retainer clip.
- Remove the 2 catalytic converter to catalytic converter bracket nuts (4) and (6).
- Loosen the three way warm up catalytic converter V-clamp (1).
- Remove the three way warm up catalytic converter (5) and the catalytic converter seal (2).
Warm Up Three-Way Catalytic Converter Installation
Install the warm up three way catalytic converter (5) to the brackets and
the turbocharger. Use a NEW warm up three way catalytic converter seal (2).
Note: Never re-us ...
Warm Up Three-Way Catalytic Converter Replacement (LUV,LUW)
Warm Up Three-Way Catalytic Converter Replacement
Callout
Component Name
Warning: Refer to Exhaust Service Warning.
...
Other materials:
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Cooling System Description and Operation
Cooling System
The cooling system maintains the engine operating temperature at the efficient
level under any speed and operating condition. When the engine is cold, the
cooling system cools the engine slowly or not at all. The slow cooling of the
engine allows the engine to warm u ...
Evaporative Emission System Hose/Pipe Replacement
Special Tools
CH-807 Closure Plugs
CH-6015 Closure Plugs
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Warning: Refer to Gasoline/Gasoline Vapors Warning.
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnec ...
0.0054