Chevrolet Sonic Repair Manual: Water Inlet Replacement (LUV)
- Removal Procedure
-
- Drain the cooling system. Refer to Cooling System Draining and Filling.
- Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.
- Remove the engine coolant temperature sensor connector (1) and the radiator outlet hose (2).
- Remove the water inlet pipe mounting fasteners (1).
- Remove the water inlet seal (3) and discard.
- Remove the thermostat (4).
- Installation Procedure
-
- Clean the sealing surface.
- Install the engine thermostat (4) into the water inlet pipe (2) with a NEW seal (3).
- Tighten the water inlet pipe mounting fasteners (1) to 9 Y (80 lb in)
.
- Install the radiator outlet hose (2) to the water inlet pipe.
- Connect the engine coolant temperature sensor connector (1).
- Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.
- Fill the cooling system. Refer to Cooling System Draining and Filling.
- After repairs, inspect cooling system for leaks.
Turbocharger Coolant Return Pipe Replacement (LUV)
Turbocharger Coolant Return Pipe Replacement
Callout
Component Name
Preliminary Procedure
Remove the turbocharger. Refer to Tur ...
Water Inlet Replacement (LUW)
Removal Procedure
Drain the engine coolant system. Refer to Cooling System Draining and
Filling.
Disconnect the engine coolant temperature sensor connector (1). ...
Other materials:
Engine Overheating
The vehicle has an indicator to warn of the engine overheating.
If the decision is made not to lift the hood when this warning appears, get service
help right away. See Roadside Assistance Program.
If the decision is made to lift the hood, make sure the vehicle is parked on
a level surface.
T ...
Steering Wheel Airbag Coil Replacement
Steering Wheel Airbag Coil Replacement
Callout
Component Name
Preliminary Procedures
Remove the steering wheel. Refer to Steering Wheel Replacement.
Remove the steering column upper trim cover. Refer to Steering Column
...
Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
Pipe Joint Compound
Note: Three types of sealer are commonly used in engines. These
are RTV sealer, anaerobic gasket eliminator sealer, and pipe joint compound.
The correct sealer and amount must be used in the proper location to prevent
oil leaks. DO NOT interchange the 3&# ...
0.0076