Chevrolet Sonic Repair Manual: Water Pump Pulley Installation
- Install the water pump pulley (2) to the water pump (3).
- Install the 3 water pump pulley bolts (1) with locking compound and tighten
to 20 Y (15 lb ft)
.
Refer to Adhesives, Fluids, Lubricants, and Sealers.
Note:
Counterhold the crankshaft balancer. The belt has to be installed for this procedure.
Caution:
Refer to Fastener Caution.
Water Pump Installation
Clean the sealing surfaces and the 3 coolant pump threads.
Install NEW gasket.
Caution: Refer to Fastener Caution.
Caution: Refer to Torque-to-Yield Fastener Caution. ...
Water Pump Pulley Removal
Loosen the 3 water pump pulley bolts (2) while holding up the water pump
pulley hub with a wrench.
Remove the 3 water pump pulley bolts (2).
Remove the water ...
Other materials:
Headlamp Aiming
Visual Aiming Preparation Procedure
Note: Some state and local laws specify requirements for headlamp
aim. Comply with all of these laws when performing any headlamp aiming operations.
Headlamp aim should be checked:
When a new headlamp capsule is installed.
If ser ...
K20 Engine Control Module: Programming and Setup
Special Tools
EL-49642 SPS Programming Support Tool
For equivalent regional tools, refer to Special Tools.
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the control module is not properly configured
with the correct ...
Range Selector Lever Cable Bracket Replacement
Removal Procedure
Set the park brake and chock the wheels.
Disconnect the range selector cable end (1) from the
range selector lever.
Disconnect the range selector cable (2) from the range
selector cable bracket.
Remove the transmission rang ...
0.0101