Chevrolet Sonic Repair Manual: Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
- Ensure that the steering wheel is set in a straight ahead position.
- Loosen the tie rod jam nut (1).
- Adjust the toe to specification by turning the inner tie rod (2). Refer to Wheel Alignment Specifications.
- Tighten the tie rod nut (1) to 60 Y (44 lb ft)
.
Caution:
Refer to Fastener Caution.
Turn Signal Switch Bracket Replacement
Turn Signal Switch Bracket Replacement
Callout
Component Name
Preliminary Procedure
Remove the inflatable restraint steering wh ...
Suspension
...
Other materials:
Fuel Pressure Measurement
Special Tools
EN 34730?E1 Pressure Tester
For equivalent regional tools, refer to Special Tools
Warning: Gasoline or gasoline vapors are highly flammable. A fire
could occur if an ignition source is present. Never drain or store gasoline
or diesel fuel in an open con ...
Exhaust Camshaft Removal
Remove the camshaft bearing cap bolts in a spiral sequence as shown one
turn at a time until there is no spring tension pushing on the camshaft.
Note: Mind the markings on the camshaft bearing caps to ensure
they will be installed in the same position.
Remove the ...
3-5-Reverse and 4-5-6 Clutch Housing Disassemble (6T30/40/45/50 - Gen 2)
Table 1:
Turbine Shaft, Reluctor Wheel and Piston Removal
Table 2:
4?? Clutch Plate Removal
Table 3:
4?? Clutch Piston Removal
Table 4:
Reluctor Wheel and Piston Removal
Table 5:
3? Reverse Clutch Plate Removal
Turbine Shaft, Re ...
0.0058