This vehicle has a computer system that indicates when to change the engine oil
and filter. This is based on a combination of factors which include engine revolutions,
engine temperature, and miles driven. Based on driving conditions, the mileage at
which an oil change is indicated can vary considerably. For the oil life system
to work properly, the system must be reset every time the oil is changed. When the
system has calculated that oil life has been diminished, it indicates that an oil
change is necessary. A
%CHANGE message
in the DIC comes on. See Vehicle Messages. Change the oil as soon as
possible within the next 1 000 km (600 mi). It is possible that, if driving under
the best conditions, the oil life system might indicate that an oil change is not
necessary for up to a year. The engine oil and filter must be changed at least once
a year and, at this time, the system must be reset. Your dealer has trained service
people who will perform this work and reset the system. It is also important to
check the oil regularly over the course of an oil drain interval and keep it at
the proper level.
If the system is ever reset accidentally, the oil must be changed at 5 000 km (3,000 mi) since the last oil change. Remember to reset the oil life system whenever the oil is changed.
How to Reset the Engine Oil Life SystemVehicle Data Recording and Privacy
The vehicle has a number of computers that record information about the vehicle’s
performance and how it is driven. For example, the vehicle uses computer modules
to monitor and control engine and transmission performance, to monitor the conditions
for airbag deployment and deploy them in a ...
Thrust Washer and Bearing Cleaning and Inspection
Warning: Wear safety glasses to avoid injury when using compressed
air or any cleaning solvent. Bodily injury may occur if fumes are inhaled
or if skin is exposed to chemicals.
Caution: Do not allow the bearings to spin. Turn them slowly by
hand. Spinning the beari ...
Heated Oxygen and Oxygen Sensor Caution
Caution: Do not remove the pigtail from either the heated oxygen sensor
(HO2S) or the oxygen sensor (O2S). Removing the pigtail or the connector will
affect sensor operation.
Handle the oxygen sensor carefully. Do not drop the HO2S. Keep the in-line
electrical connector and the louver ...