Chevrolet Sonic Owner's Manual: Automatic Door Locks

Chevrolet Sonic Owner's Manual / Keys, Doors, and Windows / Keys and Locks / Automatic Door Locks

The vehicle is programmed so that when the doors are closed, the ignition is on, and the shift lever is moved out of P (Park) for automatic transmissions, or when the vehicle speed is above 13 km/h (8 mph) for manual transmissions, the doors and the trunk/liftgate will lock.

To unlock the doors and the trunk/ liftgate press switch. on the center stack or the driver door
switch.

If equipped with an automatic transmission the vehicle must be in P (Park).

If equipped with a manual transmission the vehicle must be in Neutral with the parking brake set.

This feature can be programmed. See Vehicle Personalization.

Delayed Locking

This feature delays the actual locking of the doors until five seconds after all doors are closed. Delayed locking can only be turned on when the Unlocked Door Anti Lockout feature has been turned ...

Lockout Protection

If the driver side power door lock switch is pressed when the driver door is open and the key is in the ignition, all of the doors will lock and then the driver door will unlock. If Unlocked Door ...

Other materials:

Hydraulic Brake System Bleeding (Manual)
Warning: Refer to Brake Fluid Irritant Warning. Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution. Caution: Only use products that comply with GM specifications and check manufacturer information respectively. We recommend the use of GM genuine ...

Drive Range, First Gear Engine Braking (Gen 2)
Note: Some models of the 6T30/40/45/50 automatic transmission are equipped with an electric auxiliary fluid pump for use in hybrid vehicles (BAS+). Hybrid vehicles do not require internal combustion engine (ICE) operation at all times. After a successful engine start, the hybrid powertrain con ...

Main Shaft Disassemble (Gen 2)
Special Tools 69604356 Gear Pullers For equivalent regional tools, refer to Special Tools. Remove the 1st gear thrust washer (1) and the 1st gear (2) using 69604356 pullersand a hydraulic press. ii Remove the following components: 1st gear bearing asse ...