OnStar
Keys and LocksKey with Integrated Transmitter Programming
Keys can be programming in various ways using the procedures outlined below.
Using the Replacing Keys procedures will first erase all the known keys from the
vehicle. Any existing keys and any new keys will then be programmed. This procedure
should be used any time a key is required to be unle ...
Engine Front Cover with Oil Pump Replacement
Removal Procedure
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnection and Connection.
Set the engine to TDC. Refer to Camshaft Timing Chain Inspection.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove ...
Drive Range - Fourth Gear (Gen 2)
As vehicle speed increases, the transmission control module (TCM) processes input
signals from the automatic transmission input and output speed sensors, the throttle
position sensor and other vehicle sensors to determine the precise moment to command
OFF the normally-low 35R pressure control ...